PYLE Audio Car Video System PLVS7HM User Manual

7INCH WIDE TFT LCD MONITOR  
 
Control and layout for the monitor  
Notice: some functions are work by remote control.  
 
2
Control and layout for the remote control  
Notice: If the monitor does not have the function, the button would not be work.  
 
3
Function  
Press FUNCTION button< > on the remote or press manual button< > twice from  
the monitor to call out the function menu.  
Fixed  
Press left < > or right < >  
button to select your favorite  
FUNCTION  
display language  
PRESS UP < > OR  
DOWN < > BUTTON  
TO SELECT  
Press left button < >to adjust  
hours & press right button < >to  
adjust minute  
Press left or right button <  
>
to select auto on/off  
Press left or right button <  
to call out the calender  
>
Press the left or right button <  
to call out the game  
>
Press <  
> to invert the  
picture left or right  
Press <  
> to invert the  
picture up or down  
 
Games  
Press <  
> to enter the games.  
Start --Menu Button < >  
Move --Down Button < >  
Roll --Up Button < >  
Exit --Mute Button < >  
Level --AV Button < >  
Pause --Menu Button < >  
Move Left --Volume Button < >  
Move Right --Volume Button < >  
Calendar  
Press FUNCTION < >to call out the function menu,  
then Press <  
press left or right to <  
> to select CALENDAR and  
> to call out the CALENDAR  
Adjust increase of year, press < > button  
Adjust decrease of year, press < > button  
Adjust increase of month, press < > button  
Adjust decrease of month, press < > button  
 
Installation  
Power Cord  
(Female)  
Video 1 input (red)  
Video 2 input (yellow)  
Ground (black)  
DC 12V power input (red)  
Remote Control replacing batteries  
PULL OUT  
PUSH  
1)Always use new batteries when replacing the old set.  
2)Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.  
3)Battery replacement is necessary when remote control acts sporadically or stops  
operating.  
4)Do not drop, apply shock or step on the remote control  
5)Do not spill water on the remote control  
6) Do not place objects between the remote control and remote sensor.  
7)Do not use remote controls for other equipments at the same time.  
8)If the MONITOR does not operate even when operating the remote control from  
a close range, it is time to replace the batteries (use CR-2025), refer to the label  
on back of the basic control.  
 
4
 
Unscrew it and takeaway the back cover before  
install to headrest housing or sun-visor housing  
CAUTION: make sure the screw are not long  
enough to go through the headrest!  
If you have any doubts about this type of  
installation, please consult your local mobile  
electronics retailer. Cutting and make holes in  
the headrest will cause damage which is  
expansive to repair.  
Step of install headrest housing  
Setup work  
remove the headrest and set it in an uncluttered  
work area. Take the appropriate precautions to  
ensure that it is not damaged during the installation.  
 
6
Measurements  
Push on the headrest with your fingers to make  
sure there are no obstructions that would hinder  
the installation. Use the paper template to mark  
the area to be cut.  
Cut the headrest  
using an adjustable-depth blade, start  
your cut 1/4 inch inside one corner and  
cut diagonally across, stopping 1/4 inch in  
from the other corner. Repeat the procedure  
for the other two corners.  
Remove foam & obstructions  
Carefully peel back the material. Set the  
adjustable blade to one inch depth and cut  
around the edges of the hole, staying 1/4 inch  
inside the edge. Pull up one corner of the foam  
and use the blade to cut underneath. Remove  
small section at a time, using the pull up and  
cut method for uniform depth. Use a dremel or  
other appropriate tool to remove other  
obstructions. Insert the monitor to measure the  
fit and make adjustments if necessary  
 
7
 
Step of install sun-visor housing  
Setup work  
remove the visor and set it in an uncluttered  
work area. Take the appropriate precautions to  
ensure that it is not damaged during the installation.  
Measurements  
Push on the headrest with your fingers to make  
sure there are no obstructions that would hinder  
the installation. Use the paper template to mark  
the area to be cut.  
Cut the visor  
using an adjustable-depth blade, start  
your cut 1/4 inch inside one corner and  
cut diagonally across, stopping 1/4 inch in  
from the other corner. Repeat the procedure  
for the other two corners.  
 
9
Remove foam & obstructions  
Carefully peel back the material. Set the  
adjustable blade to one inch depth and cut  
around the edges of the hole, staying 1/4 inch  
inside the edge. Pull up one corner of the foam  
and use the blade to cut underneath. Remove  
small section at a time, using the pull up and  
cut method for uniform depth. Use a dremel or  
other appropriate tool to remove other  
obstructions. Insert the monitor to measure the  
fit and make adjustment if necessary  
Route the cable through the visor  
Run the supplied cable through the opening  
and out the top of the visor. If possible,  
conceal the wires using a shaft covering.  
Connect the power, ground and video leads to  
test the MONITOR.  
Before connecting the monitor, pull the  
connecting cable assembly through the  
visor housing as shown in diagram. Place  
visor housing into the opening and secure with  
correct fasteners.  
Install the sun-visor housing  
Pull the connecting cable through the center of  
the housing as shown in diagram, and secure with  
correct fasteners  
Download from Www.Somanuals.co1m0. All Manuals Search And Download.  
 
 
Technical parameters  
LCD Drive Method: TFTActive Matrix  
Display Size: 7 Inch Wide Screen (Diagonal)  
Aspect: 16:9  
Display Format: 480 x RGB x 234  
Number of Pixels: 1440 x 234  
Video System Input: NTSC/PALAuto-select  
Back Light: High Brightness Type U Shaped CCFT  
Power Source: DC12V  
Current Consumption: 8W  
Dimension (H x W x D): 113 x 182 x 25 (mm) Stand Style  
Dimension (H x W x D): 128 x 195 x 24 (mm) Headrest Style  
Dimension (H x W x D): 127 x 236 x 25 (mm) Sun Visor Style  
 

Peavey Music Mixer SRC 4018 FC User Manual
Pentax Digital Camera 16811 User Manual
Perle Systems Switch RPS1620 User Manual
Philips Digital Photo Frame 9FF2CME9FF2M4 User Manual
Philips Portable DVD Player DCP851 User Manual
Philips VCR VR 520 User Manual
Pioneer DVD Recorder DVR 218L User Manual
Plustek Photo Scanner Plustek SmartOffice Series User Manual
Poulan Chainsaw P3314 User Manual
Pro Ject Speaker Bach User Manual